Checkpoint R75.20

I downloaded the trial version of FSM, 6.4 build 6.4-309-20121128, and have found the following problems.  Has anyone else used FSM with CheckPoint, and not run into this?

1) Several of my rules use the legacy UserGroups, but in FSM, they show up as Any rather than an object UserGroups.

2) I tried to run Optimize, and exported a logfile to my workstation.  After pointing it to that log file, FSM runs for a few minutes, and then reports "[C:\SmartSPLAT\exported_log.txt]  >>Did not find any valid entry in the log that matched the host Bastion1<<"

     I have two firewalls, Bastion1(10.1.1.1) and Bastion2(10.1.1.2) in a Checkpoint Cluster.  When in created the Firewall Inventory, I used the File System as the configuration source, and imported the objects_5_0.C, rulebases_5_0.fws and route_rules.  I selected Bastion1 as the install target.  In the exported.log file, the orig value is 10.1.1.1, i.e. bastion1.

1;27Feb2013;23:59:00;10.1.1.1;log;accept;;Internal;inbound;VPN-1 & FireWall-1;;45;{87787169-3B45-4E17-9C99-F7078CBECE7A};WSG-Open Out;domain-udp;10.1.20.9;113.142.16.68;udp;204.180.236.5;;37;1;53;62557;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;

But it seems that FSM is looking for the word Bastion1 rather than the IP address.

Ideas?